Introduction

Installation of an under sink water heater can be so easy if only you have some basics on plumbing. In this way, you can save up to $300 which should have been paid to a plumber. Below are simple and procedural ways on how you can install a hot water system.

First of all, you will need tools necessary to complete this task. Below is a list of tools that are needed for this handy job:

An adjustable wrench; Pipe wrench; Nippers; Pliers4-in-1 screwdriver; Plumbers tape; Safety glasses; Soldering torch and flux; Tube cutter; Tape measure; Slip joint pliers; Gas-rated thread

It is to be noted that even if you have with a plumbing company or indulged in gas lines, you must contact your local department for inspections and if a permit is required, get it.

Process of Installation of a Water Heater

Below is a process of tank installation and also shows how to replace your water system in case of any problem for those already with the system in place. The procedure is as shown below:

Turning off the Gas and Water

Both the water and gas supply have to be turned off for efficiency and safety … Read More